A plate bracket used for attaching bearings off of the side of 1×1 tubing. These brackets can be double-stacked to provide additional strength and support for .25in thick bearings. Here are some feature highlights:
- .125in thick for strength.
- 1.125in bearing hole.
- .196in holes for use with #10 fasteners or 3/16in rivets.
- Sold in packs of 2.
- Laser-cut from 5052 Aluminum.
- Weighs approximately .054 pounds.
Note: Due to the small number of holes and the potential for high loads on these brackets, it is advised that these brackets be mounted with bolts or screws rather than rivets.
Set of 2.