A plate bracket used for joining two pieces of 2×1 tubing at a 135 degree angle. These brackets are commonly used for harvester-style floor loader mechanisms (like were seen on many 2014 FRC robots). It is a 2in wide version of CRP_B_008. Here are some feature highlights:
- .080in thick for a balance between strength and weight savings.
- .196in holes for use with #10 fasteners or 3/16in rivets.
- Sold in packs of 2.
- Laser-cut from 5052 Aluminum.
- Weighs approximately .069 pounds.
Special attention was paid to the hole-pattern on this bracket. The holes are positioned so a piece of tube stock with a hole pattern starting .5in from the edges of the tube will line up with the holes in the bracket when the tube is mitered to match the angle.
Set of 2.